LiteDimmerTM

DMX Transmit

Watch Video or Read Below

DMX TRANSMIT mode enables the user to operate the ballast in LOCAL MODE while simultaneously outputting Spectrum-formatted DMX signal. This signal can carry up to 12 Pixels and can be sent to other Spectrum ballasts over LumenRadio wireless or with DMX cable.

 

1. Set main 3-position switch to the CENTER position

 

 

2. Press the function button on the display below ‘SETTINGS’

 

 

3. Rotate the left encoder knob to navigate to ‘OUTPUT SETTINGS’ and press the knob to select it

 

 

4. Rotate the left encoder knob to navigate to ‘DMX TRANSMIT’ and press the knob to select it.

 

 

5. Rotate the left encoder knob to choose either ‘OFF’ for Receiving ballast(s) and ‘ON’ for Transmitting ballast.

 

 

 

6. Once Output settings have been selected, press the left encoder knob to navigate back to the main screen.

 

7. On Receiving ballast(s), set main 3-Position Rocker Switch to the down position.

 

 

8. From OFF position, set Wireless DMX Switch to RX.

 

 

9. Press and hold the Wireless DMX Link/Status Switch till indicator light shuts off.

 

 

10. On Transmitting ballast, set main 3-Position Rocker Switch to the down position.

 

 

 

11. From OFF position, set Wireless DMX switch to TX.

 

 

 

12. Press the Wireless DMX Link/Status Switch on Transmitting ballast.

 

 

13. The blue indicator light will begin flashing on devices.

 

 

14. When the units link, the blue indicator light on the Wireless DMX Link/Status Switch will remain on.

 

 

15. Use the encoders on the Transmitting ballast to control fixtures.

 

 

16. If fixtures functions correctly, you have properly linked ballasts and may proceed to use.